Subaru Impreza 1 Remove Door Panel

This 3 Piece Kit Comes With The Upper Rear Deck Panel, Back Panel And The Lower Rear Seat Panel.

It will not break, just do a little forcing. Give your impreza interior a fresh, unique, finished appearance similar to subaru wrc factory race cars. Low prices, proven reliability, fast shipping

Our Lightweight Door Panels Are Designed To Fit With Most Cages.

You don't have to remove that screw on that piece either. Also it sucks to do. Use the flathead screwdriver to pry off the door panel, starting from the outside edge of the door.

After The Trim Is Off The Panel Slides Over It.

Then pop off the plastic cover by the handles, then there may be another screw or two. Also keeps all the plastic looking nice and black and shiny. From here, the door panel is held on entirely by snap gromets, so just pull of the panel all around and it will eventually pop off.

Switch Pod On The Driver Door Panel Allows For Use Of The Factory Window Switches.

So i've been wondering whether it's possible to remove the plastic panels at the bottom of the doors, above the rocker panels. This guide for front door panel replacement will result in the successful removal of the front door panel. Pick up the bolt that's at the bottom of the door (i found a nut, too.

You Do Need To Give It A Good Tung Once All Screws Are Taken Off, Good Luck!

Lift the door panel off the top lip once all the plastic clips have been popped out. There is also a pop out piece that you can only get to when the door is open. Pull the door handle and you will notice a little indent on the trim.